|
  |
 |
 GSXR1000 K5 |
|
FITTING
INSTRUCTIONS FOR R&G LICENCE PLATE HANGER
SUZUKI GSXR1000K5 (part code LP0012BK)
-
Remove upper rear seat cowl
-
Disconnect number plate light loom
-
Using a 10mm socket and ratchet, carefully loosen all four hex head
set screws, securing current tail assembly
-
With all tension removed, continue to unscrew the four screws,
whilst supporting assembly with your free hand
-
You can now lower the assembly with only the loom in contact with
the bike
-
Using the original set screws, raise the new R&G tail tidy into
position and insert and start each fixing by hand first, to prevent
any cross threading
-
Once happy that all four fixings are successfully started, continue
to tighten them all equally
-
Tighten all four firmly but do not overtighten, or damage to the
licence plate hanger or the bike will result
-
Pass licence plate illuminator wire up through the R&G unit and
connect in place of the original
-
With the tail tidy now in position you can fit up with your choice
of accessories. The R&G loom should be carefully routed through
the hole provided
-
Connect loom and replace upper rear seat cowl to complete the task
|
| |
|
|
|
Consumer Insert
The catalogue description and any exhibition of samples are only broad
indications of the Products and R & G may make design changes which do
not diminish their performance or visual appeal and supplying them in
such state shall conform to the order.
The Buyer acknowledges no representation or warranty (other than as to
title) has been given or will apply to the Products other than those in
R & G’s order or confirmation and the Buyer confirms it has chosen the
Products as being of merchantable quality and suitable for its
particular purposes.
Where R & G fits the Products or undertakes other services it shall
exercise reasonable skill and care and rectify any fault free of charge
unless the workmanship has been disturbed. The Buyer is responsible for
ensuring that the warranty on the motorcycle is not affected by the
fitting of the Products.
On return of any defective Products R & G shall at its option either
supply a replacement or refund the purchase money but shall not be
liable if the Products have been modified or used or maintained
otherwise than in accordance with R & G’s or manufacturer’s instructions
and good engineering practice or if the defect arises from accident or
neglect.
Other than identified above and subject to R & G not limiting its
liability for causing death and personal injury, it shall not be liable
for indirect or consequential loss and otherwise its liability shall be
limited to the amounts paid by the Buyer for the Products or the fitting
or service concerned.
These terms do not affect the Buyer’s statutory rights.
R&G RACING RETURNS POLICY (NON-FAULTY GOODS)
Returns must be pre-authorised (if not pre-authorised the
return will be rejected)
Goods may only be returned direct to us if they were purchased direct
from us (customer must prove if necessary). Otherwise to be returned to
original vendor.
Goods must be in re-sellable condition, in the opinion of R&G Racing
All returns are subject to a 25% restocking and handling fee (25% of the gross value exc. P&P – at the prevailing price at time of purchase)
The customer must pay any and all carriage charges
No returns of discontinued products, unless within 14 days of purchase
This policy does not affect your statutory rights and does not refer to
faulty goods
|
|
| |
<<Back |
|
All crash protector and frame slider prices
include VAT at 17.5%. Postage & Packaging is dependent on weight of total
order
Key: S=Set
P=Pair E=Each
/
Crash
protectors and frame sliders /
|
|
