PLEASE NOTE THAT THE WAY THE KIT IS
PACKED DOES NOT NECESSARILY REPRESENT THE WAY OF MOUNTING TO THE BIKE
Undo
the engine bar located mid engine
Take
R&G tie bar, remove bobbins, then remove one end (22mm spanner fits)
on the stainless steel extension.
The
turned-down section goes in and sits down into the frame.
Push
bar right the way through engine (in bolt’s original position).
Put on end of tie bar and tighten extension.
Refit
fairings
Fit bobbins.
Due to the risk of
cross-threading of bolts etc; we always recommend that our products be
fitted by one of our official dealers or a qualified mechanic.
Consumer Insert
The catalogue description and any exhibition of samples are only broad
indications of the Products and R & G may make design changes which do
not diminish their performance or visual appeal and supplying them in
such state shall conform to the order.
The Buyer acknowledges no representation or warranty (other than as to
title) has been given or will apply to the Products other than those in
R & G’s order or confirmation and the Buyer confirms it has chosen the
Products as being of merchantable quality and suitable for its
particular purposes.
Where R & G fits the Products or undertakes other services it shall
exercise reasonable skill and care and rectify any fault free of charge
unless the workmanship has been disturbed. The Buyer is responsible for
ensuring that the warranty on the motorcycle is not affected by the
fitting of the Products.
On return of any defective Products R & G shall at its option either
supply a replacement or refund the purchase money but shall not be
liable if the Products have been modified or used or maintained
otherwise than in accordance with R & G’s or manufacturer’s instructions
and good engineering practice or if the defect arises from accident or
neglect.
Other than identified above and subject to R & G not limiting its
liability for causing death and personal injury, it shall not be liable
for indirect or consequential loss and otherwise its liability shall be
limited to the amounts paid by the Buyer for the Products or the fitting
or service concerned.
These terms do not affect the Buyer’s statutory rights.
R&G RACING RETURNS POLICY (NON-FAULTY GOODS)
Returns must be pre-authorised (if not pre-authorised the
return will be rejected)
Goods may only be returned direct to us if they were purchased direct
from us (customer must prove if necessary). Otherwise to be returned to
original vendor.
Goods must be in re-sellable condition, in the opinion of R&G Racing
All returns are subject to a 25% restocking and handling fee (25% of the gross value exc. P&P – at the prevailing price at time of purchase)
The customer must pay any and all carriage charges
No returns of discontinued products, unless within 14 days of purchase
This policy does not affect your statutory rights and does not refer to
faulty goods
