Remove
fairing Place
offside aluminium fairing bracket (note: components are marked "offside"
and "nearside") against triangle side of frame Using
the two clamps and the four bolts supplied, secure bracket to frame Install
tension bar and repeat above procedure on opposite side Insert suitable
marking tool to enable an impression to be made on the inside of the fairing Replace fairing
panel to obtain mark (suggest Tippex or paint) Remove fairing panel Using a 25mm hole
saw, drill pilot hole only Replace fairing
to check alignment Remove panel. Hold
the panel securely, pick up on pilot hole and drill slowly with 25mm
hole saw (note the panel must be drilled from the outside towards
the inside) Repeat on the other
side Replace fairings Install bolt through
crash protectors Slide protector
neck through the new fairing hole Secure tightly (suggest
Locktite on bolt)
Consumer Insert
The catalogue description and any exhibition of samples are only broad
indications of the Products and R & G may make design changes which do
not diminish their performance or visual appeal and supplying them in
such state shall conform to the order.
The Buyer acknowledges no representation or warranty (other than as to
title) has been given or will apply to the Products other than those in
R & G’s order or confirmation and the Buyer confirms it has chosen the
Products as being of merchantable quality and suitable for its
particular purposes.
Where R & G fits the Products or undertakes other services it shall
exercise reasonable skill and care and rectify any fault free of charge
unless the workmanship has been disturbed. The Buyer is responsible for
ensuring that the warranty on the motorcycle is not affected by the
fitting of the Products.
On return of any defective Products R & G shall at its option either
supply a replacement or refund the purchase money but shall not be
liable if the Products have been modified or used or maintained
otherwise than in accordance with R & G’s or manufacturer’s instructions
and good engineering practice or if the defect arises from accident or
neglect.
Other than identified above and subject to R & G not limiting its
liability for causing death and personal injury, it shall not be liable
for indirect or consequential loss and otherwise its liability shall be
limited to the amounts paid by the Buyer for the Products or the fitting
or service concerned.
These terms do not affect the Buyer’s statutory rights.
R&G RACING RETURNS POLICY (NON-FAULTY GOODS)
Returns must be pre-authorised (if not pre-authorised the
return will be rejected)
Goods may only be returned direct to us if they were purchased direct
from us (customer must prove if necessary). Otherwise to be returned to
original vendor.
Goods must be in re-sellable condition, in the opinion of R&G Racing
All returns are subject to a 25% restocking and handling fee (25% of the gross value exc. P&P – at the prevailing price at time of purchase)
The customer must pay any and all carriage charges
No returns of discontinued products, unless within 14 days of purchase
This policy does not affect your statutory rights and does not refer to
faulty goods
916/996/748
Remove
fairing